Garage Door Closes Part Way Then Opens Again

Remove the bell wire from the single button control station s terminals and operate the garage door opener from the remotes.

Garage door closes part way then opens again.

When this happens your garage door will only close by holding down on the wall button until the door fully closes. The remotes will not work to close the garage door. If your garage door won t open or close the problem could be a bent track a broken torsion spring or a bad capacitor int he motor housing. Outside of those things you may need to have a technician come and check the unit s out.

If there is a force adjustment out of range that could potentially cause this issue. You push the button to close the garage door. They can only open it. Disconnect the control station.

Get logic board replacement. Verify that the mounting brackets for the sensors are secured tight and the sensors are not vibrating while the door is closing. If it closes only partway the safety sensors are usually responsible clean the lenses or realign them and make sure there are no obstacles blocking the beam. If the door reverses part way down and you are sure there is no obstruction or binding increase the closing force a small amount and try it again.

Some older garage door openers do not have nicely labeled adjustment screws for force and travel limits. Close the garage door with the opener and watch it closely as it closes. When your liftmaster garage door opener opens and closes by itself here are the troubleshooting tips you need to follow. If the garage door does not close completely or begins to close and then opens back up again the down limit switch needs.

It goes partway down reverses direction and goes back up again. This is almost always the result of a dirty or obstructed safety feature. If your garage door is closing fully and then reversing to open again then it may be due to a problem with the close limit switch. When the logic board wears out it can cause your garage door to close then open and vice versa without explanation.

In order to fix this you ll want to make small changes to the close limit setting until the door opener knows to stop once the door has reached the floor.