Once all the safeties are proven the electronic ignition control board will send a signal to the gas valve.
Furnace gas valve intermittent.
This item was spot on for the job.
The burner and pilot shut off when the correct temperature is reached.
This problem can be observed when the intermittent pilot or the direct ignition of the main burners ignite and then extinguish itself right away.
Intermittent pilots use electronic ignition systems to create heat.
Even though these systems are generally built to last gas furnace valves are the parts more likely to need replacement over the life of.
That may be the only problem.
Electronic ignition gas furnace problems and troubleshooting furthermore the next most common problem for furnace troubleshooting that can occur is the flame sensor or flame rectifier.
I have been researching how to diagnose this intermittent lighting issue with my furnace but the common issues do not seem to apply.
That would give you the intermittent issue.
If it lighted and then went out it could just be a dirty flame sensor electrode bad ignition module or gas valve.
You would need to take out the electrode and clean it off with an emery cloth or light sand paper.
When an electric signal is sent to the burner a solenoid releases gas into the pilot and warms a heating element or emits a spark to ignite the gas.
The command will be to open either the main valve if it is direct ignition or to light the intermittent pilot light.
The burner is then activated and warms the home.
This universal valve can do either natural gas or be converted to lp.
It took quite a bit of research to make sure this one was compatable.
Blower turns on ignition coil turns cherry red sound of gas blo.
Goodman gas furnace intermittent gas valve problem.
Replace my own gas valve for our lennox furnace.
Getting less than 24 volts may 18 volts causing the valve to goodman gas furnace intermittent gas valve problem.
It comes as a 3 4 but has 1 2 reducers with it.
In gas heating repair safety is always first.